Honda Door Lock Actuator Screws Stuck

Remove the single screw in the middle of the gold plate taking care to note the position orientation of the small locking lever.

Honda door lock actuator screws stuck.

If you are having problems with your door locks this is the video for you make sure to watch until then. Car door lock actuators are designed to lock and unlock a door without the effort of pulling on a cable and rod. The lock actuator is behind this screw. Unclip the broken actuator from the locking assembly.

The 2010 honda cr v has 4 problems reported for door lock actuators failed. Take the inside door release lever panel off and push the lever rod all the way to the rear. 2007 honda cr v door lock actuator repair. There is many helpful tips and tricks to aid you in.

Average repair cost is 610 at 84 500 miles. Remove this screw and unhook the tabs holding the black plastic housing for the actuator. Observe the plastic tab above and beneath this screw. Just unhook and slide through the holes on the metal.

Using a screwdriver test that the locking mechanism works by locking the latch then checking if the door latch releases using the outer handle lever. Install the lock subassembly onto the new door lock actuator using the new screws from the kit p n 72116 swa a01 and p n 72116 swa 003. A rod connects the actuator to the latch and another rod connects the latch to the knob that sticks up out of the top of the door. In some cars the door lock actuator is positioned below the latch.