The wheels on the glass sliding patio door have an adjustment screw at the bot.
How to adjust screws on sliding screen door.
Give the screw a clockwise turn and test to see whether the door slides easier.
Slowly raise the other roller until there s an even gap between the door and the track.
Locate the first screw on the sliding screen door wheel assembly.
Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.
Turn the adjustment screw counterclockwise and lower the door until it rests on the track.
There should be a uniform gap along the bottom and top edges of the door.
The adjustment screws are on the wheel assemblies at the top or bottom of the door.
Most sliding glass doors contain two sets of rollers one on each side of the bottom of the door.
If the side with the adjusting screw is too high causing it to bind at the top turn the screw counterclockwise.
Adjust the door by turning the adjustment screws.
If it s too low use a flat pry bar to raise the door while you turn the adjusting screw clockwise.
Use the screwdriver to adjust this first screw.
To reinstall the screen door focus on the upper wheels first.
You can alter the height of these rollers by accessing the adjustment screws which are set into slots on the door s outer edges perpendicular with the rollers themselves.
Locate the adjustment screws on the lower edges of the door.
Then turn the screws until the frame is parallel with the jamb edge.
The screw is beside the wheels but is not the screw holding the wheels onto the door.
Turn the screw clockwise.
Fit the door back on its track to test it.
From the jamb edge.
Turn the tension screws clockwise until the door is secure and well aligned with the strike on the frame.
Turning the screw clockwise will cause the sliding screen door to become higher as the wheels lower.
The lubricant will.
Regular vacuuming of the track will help keep the door sliding smoothly.
How to fix a glass sliding patio door that dosnt roll close or lock properly.
Turning this screw raises or lowers the roller.
Push them into the upper track then set the door on top of the lower track.
If the door becomes even harder to open turn the screw in the opposite direction.
The bottom of the frame should be about 1 8 in.
After a bit of adjustment the door should roll easily without rubbing on the bottom track.
Then raise it one roller until it lifts the door about 1 4 in.
Position the door so the frame is about 1 4 in.
Do the same at the other end of the door.