How To Adjust Spacing In Garage Door Panels

Replacing individual garage door panels.

How to adjust spacing in garage door panels.

I know that this information is very helpful when installing a garage door. Make sure the lag bolts that attach the clips to the framing are tight. Get the track where you want it and tighten the clips back down. Using a screwdriver loosen the screws which hold the tracks in the garage door frame.

It can happen to the best of us. The cable is attached to the door and runs to an s hook that attaches to the track support. Adjusting the garage door track margins keeps the track properly aligned with the door itself. You can buy them in any diy store and they re very easy to install.

Adjusting the position of the track tap the bottom of the track gently with a rubber mallet. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. Now you can align the track so it is perfectly vertical by tapping it at the bottom with a rubber mallet. When it is resting on the ground the door establishes where the tracks should be.

If there s a slight gap at the bottom of your garage door then a garage door threshold is a great option. Lift the top rod upward to move the bottom rod until it s flush against the door to adjust the tension in the spring. The image below will show you how this works. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.

Install a garage door threshold. That means that the sections will fit together without a gap. Use a spirit level to identify when. Lower the garage door clamp or bolt it shut so it can t open and insert 1 metal rod into 1 of the holes around the perimeter of the spring.

With the door propped open take the s hook out of the support and tighten or loosen the cable as needed. Use a screwdriver to loosen the screws that are in the tracks to secure it to the garage door frame. Then insert another rod into a hole below the rod you already inserted. This will help to position it to the correct spot.

The panels for this type of door are a tongue and grove type. They come with a rubber threshold and glue and sometimes a caulking gun too. Diy guide to garage door track adjustment. If you need further assistance please reply to this thread.