Apply the stucco to the wall with a trowel to a thickness of 1 8 inch.
How to apply stucco to concrete wall.
Use a masonry trowel to apply the mud in overlapping arcs to the wall.
The scratch coat should be between 1 4 and 1 2 inch thick.
This first coat is known as the scratch coat this coat helps the final coat bond properly to the wall.
Mix finish coat stucco with water to the same consistency as the base coat adding stucco colorant as needed to give the material the desired hue.
Stucco is a common finish material used in residential and commercial construction both for interior and exterior settings.
Use long strokes knife swaths and other techniques to give the stucco the desire texture.
Right before you apply the plaster wet the wall to improve the suction bond and reduce the amount of water the wall absorbs from the plaster.
How to apply stucco over old stucco.
Prep the wall surface by spraying the block with water to prevent the stucco from drying too quickly.
When installed properly it will.
Then apply inch thick scratch coat and score it with shallow horizontal lines.
Use the flat finishing trowel to spread the stucco evenly across the surface.
To apply stucco to your existing brick block or concrete wall first brush a concrete bonding agent onto the wall then allow it to dry completely.
Flatten the final texture with a trowel.
Work from the bottom of the wall up and apply at a thickness of about 3 8 inch over the entire area.
After the bonding agent has been allowed to dry the stucco can be applied directly to the wall.
To stucco a house of made out of concrete or masonry make sure the surface of the walls is roughly textured and absorbent.
Then trowel the surface to your preferred texture.
The application of the stucco should begin with a scratch coat a 1 4 to 1 2 layer of mortar which is.
So hi i m micah garrett with buildblock building systems and today we re going to be talking about how stucco is applied to an icf wall systems.
Stucco a masonry or concrete wall.
When you drag a hoe through the stucco it should be just thick enough to hold its form.
Apply the first coat of stucco to the concrete surface.
Allow the scratch coat to harden slightly.
Some of the basics of stucco is typically this is an eiffs style stucco application.