How To Attach Bathroom Sink To Wall

Locate the large nut that connects the sink to the drain and disconnect it.

How to attach bathroom sink to wall.

Loosen the slip nut at the top of the p trap. Attach the vanity to the wall using 3 inch drywall screws. Be sure to use a masonry. Installing a bathroom sink in a vanity is made easier by the fact that the supply lines and the drain all remain hidden within a cabinet.

Have a small bucket ready to catch any water. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Mount the sink to the wall. Turn off the water supply.

Prepare the faucet drain and pop up. If the holes are not completely lining up or you want a more. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers. Set the sink on top of the pedestal then slide the sink close enough to the wall so you can insert the winged toggles into the mounting holes in the wall.

Use plumber s putty as you attach the. If not turn off the water at the main valve. Lift the sink slightly while tightening the nuts with a wrench. Check the level again before trimming the shims with a utility knife.

Ideally i would like to mount the sink using only the two rear tabs bolted to the wall. Lift the back edge of the sink onto the bracket. For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink. If the cabinet has no back simply attach it to the wall so it encloses the plumbing.

The valves are typically under the sink. If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain. If there are large gaps at the wall or floor attach quarter round moulding along the wall or floor edge. Then turn on the faucet.

The pockets are not deep enough for the tabs on my sink the holes do not align etc. Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it. Follow manufacturer s directions for the size and depth of. Attach the sink 1.

Verify the toggled wings open once you. Drill pilot holes into the wall at the marked locations. Remove the entire trap if necessary. This metal or plastic nut will be located either in the wall or the floor.

Drill your pilot holes for the lag screws which should be included with your wall mount sink. Use the template that comes with the sink to mark the. The standard cast iron brackets available for vintage sinks do not seem designed for this sink s brackets. Use your hands or locking pliers to unscrew the nut.