How To Attach Cord To Garage Door Bottom

Pull the cable as tight as possible before tightening the setscrews.

How to attach cord to garage door bottom.

Attach weather stripping to the bottom edge of garage door. Screw cable brackets to the door to secure the weather stripping. Diy garage door repair and save money. Prepare the new cable by cutting off any pieces of tape wrapped around it.

Rotate the drum to wind the cable into the winding grooves. Clamp it into place. Then drill and screw the track to the back of the door using 1 in. Insert rollers into the brackets attached to the door.

Always be careful when using a sharp knife. If your garage door cable is at an angle or l. The cables attach at the bottom end to the bottom bracket that is mounted to the bottom of the bottom panel. Remove the cable from the bottom bracket and then completely remove the cable from the door.

With the cable behind the roller and bracket install the bottom bracket on the garage door. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Now attach the cable to the bottom bracket. Use impact driver to mount hinges to the bottom panel of garage door.

This video will show you how to repair a mis aligned garage door cable. Push the track into wet caulk and tight against the door bottom. Leave the locking pliers in place and repeat the tightening procedure on the other side. Install the roller into the bottom bracket and thread the cables behind the rollers on the door.